|
 |
| Digi Switch - 20 Volt / 20
Amp Remote Switch |
|
|
Click on image for viewing |
Remote Switch 20 Volt / 20Amp .
Turn on/off devices remotely using spare RX channel (ie landing lights, smoke
systems, cameras etc).
- 8 Bit Pic Microcontroller
- Lipoly or Ni-Mh/Ni-CAD input
- 20 volt 20 amp Mos-Fet output
- DSP Noise / Loss of Signal filtering
- PPM-PCM 2048 - 1024 Input
- Small size 12-Grams
- 100% surface mount technology
- Low voltage drop less then 150mV
- 22Ga heavy wires
- Ideal for motor or Night flying systems
|
|
|
User Guide |
|
| Power Plus - Voltage
Regulator |
|
|
Click on image for viewing |
|
Power Plus - Voltage Regulator
Specifications
· 8 Bit Microcontroller
· 3.3 ~ 8.2 Volt Output User Adjustable
· Deans Plugs
· 10 Amp output - 70 watts
· Daylight LED’s
· Voltage input max 10 Volts D.C [ (2) cells Li-Poly - (2) A123 cells -
(7)-Ni-Mh Cells ]
· Max output 8.20 Volts D.C [8.40 volts input]
· Min Output 2.33 Volts D.C
· Max Current output 10A [14 Amps Peak 30 seconds]
· Low voltage indication point 6.8 volts [ under 20% of pack remaining ]
· Duty cycle 100% when volts > 6.50 (10 Amps 100% of the time)
· Duty cycle 70% when volts > 6.0 (7.0 Amps 70% of the time)
· Duty cycle 50% when volts < 6.0 (5.0 Amps 50% of the time)
· 5.0V or 5.1V should only be used if you MUST have it for a Heli system. The
system gets very hot running 5.0 volt outputs.
|
|
|
User Guide |
$39.95 |
|
| |
 |
DX-7 Super cap
42% Products , "Super Cap"
Capacitor to plug into receiver to help
reduce receiver resets due to volt drops
under load.
Often used with Spektrum Receivers |
|
|
$11.95 |
|
| 10 amp regulator with Trex connectors |
|
Click on image for viewing |
- Plug & Play design
- Large heat sink for optimum performance, Weight: 1.4oz /
40 grams
- Input Range: 4.8V -12V.
- Output is factory preset to 6.50V, fully adjustable
between 5V and 6.5V,
- Continuous Current: 10 Amp @ 7.4V input & 6V output. 20
Amp @ 7.4V input & 6V output at 75 deg ambient,
- Dimensions: 60mm long by 25mm wide by 16mm deep.
This is the perfect regulator for a 50cc & 100cc class models and dual
battery setups
Mounting Kit included
Low Loss 16Ga wires
|
|
|
|
$31.95 |
|
| Heavy Duty Power Switch with Charge Jack and
Sliding dust cover |
 Click on image for viewing |
|
Standard switch size, with JR leads and silicon gasket, mounting plate and
screws.
Good quality switch
DSC Compatible
|
|
|
|
$13.95 |
|
|
|
