42% Products Blue-Box 8/16 Power Distribution System. 

LIPO/LION or NICAD/NIMH (4 & 5 cell) Version now also available contact us for details

• 8 Inputs (A,B,C,D,E,F,G,H)
• 16 Buffered/Filtered and amplified outputs (A,A,A,A,B,B,B,B,C,C,D,D,E,F,G,H)
• Both power and servo signal are amplified - Can drive up to 10 meters servo wire per channel !
• Servo power output equals power input ( ie input 7volts, and servos receive 7 volts)
• 5 Volt 1.5 Amp Regulated output for receiver on all channels for improved redundancy
• "Flight Deck" for mounting receiver at top of board. Can be removed (permanent) if desired
• Dual Battery Inputs - Auto Load sharing and failsafe switch over
• "Power Match" LEDs show which battery is battery is being used, or when both are equal
• Includes rubber grommets and aluminum standoffs and screws
• 64 Amp power bus (32 Amp per input)
• Deans Input  Connections
• 6 volt Minimum input is required for Lion/Lipo version (pref regulated) - 6v minimum not required for NiMh/Nicad Version
• 10 Volt Max Input
• Designed for 2 cell Lipo/Li-Ion/LiFe (A123) - Dedicated NICAD/NIMH (4 & 5 cell) Version now available contact us for details
• Includes 6 leads for connection to receiver, additional leads can be purchased seperately
• Works with PPM , PCM, 2.4Ghz systems

42% Products Blue-Box 12/24 Power Distribution System. 

LIPO/LION or NICAD/NIMH (4 & 5 cell) Version now also available contact us for details

• 12 Inputs
• 24 Buffered/Filtered and amplified outputs
• Both power and servo signal are amplified - Can drive up to 10 meters servo wire per channel !
• Servo power output equals power input ( ie input 7volts, and servos receive 7 volts)
• 5 Volt 1.5 Amp Regulated output for receiver on all channels for improved redundancy
• "Flight Deck" for mounting receiver at top of board. Can be removed (permanent) if desired
• Dual Battery Inputs - Auto Load sharing and failsafe switch over
• "Power Match" LEDs show which battery is battery is being used, or when both are equal
• Includes rubber grommets and aluminum standoffs and screws
• 72 Amp power bus ( 36 Amp per input)
• Deans Input  Connections
• 6 volt Minimum input is required for Lion/Lipo version (pref regulated) - 6v minimum not required for NiMh/Nicad Version
• 10 Volt Max Input
• Designed for 2 cell Lipo/Li-Ion/LiFe (A123) - Dedicated NICAD/NIMH (4 & 5 cell) Version now available contact us for details
• Includes 6 leads for connection to receiver, additional leads can be purchased seperately
• Works with PPM , PCM, 2.4Ghz systems