Gas Engine Accessories

Opto Gas Engine Kill Switch

Click on image for viewing

User Guide

Remote Electronic
Ignition kill switch

This device allows you to safely and remotely kill your electronic ignition equipped engine from your transmitter. Opto coupled to isolate your ignition from your radio equipment to ensure interference free operation. Includes a bright LED light (remote mountable) to indicate that the ignition is armed when on.

OPTO Coupled input/output
8 Bit Pic Controller
Li-Po/Li-Ion/Ni-Mh/NiCad input
Upto 20 Volt 15 amp Mos-Fet output
DSP Noise / Loss of signal Filtering
PPM-PCM 2048 – 1024 & 2.4Ghz Interface Support
Low Voltage Drop – Less than 150 mv
100% Surface Mount Technology
Heavy Gauge Wires, universal connectors.
Small and light weight – only 12 Grams!

Z-Kill - Magento Ignition Gas Engine Kill Switch

Click on image for viewing

User Guide

Z-KILL - Remote Ignition Kill switch for Magneto Ignition Systems (ie Zenoah)

This device allows you to safely and remotely kill your magneto ignition equipped engine from your transmitter. Used for engines that have a magneto type ignition such as Zenoah, Fuji, Quadra, and Conversion type engines.

• 8 Bit Pic Microcontroller
• DSP Noise / Loss of Signal filtering
• PPM-PCM 2048 - 1024 & Spread Spectrum
• Small size 22-Grams
• 100% surface mount
• 220 v 10 Amp relay interface
• Heavy wires

1.5 Amp Ignition Regulator
Click on image for viewing	1.5 Amp Ignition Regulator. Allows you to use your CDI/Electronic ignition with LI-PO, LI-ION and 5 Cell NiMh/NiCad Packs Plugs in between battery switch/kill switch and the ignition unit. Suitable for DA/DL ignitions and most other brands that are limited to 6 Volt inputs. Voltage input : 7.0 to 15.0 Volts D.C 2 ~ 3 cell Li-poly/Li-Ion cells / 5 Cell Nicad & NiMh Output 5.0V @ up to 1.5 Amps Max load This is for accessory items (ie Ignitions, Gyros etc) only, it is not intended for multi servo applications of any type.